![]() ![]() Footplate AdjustmentTo complete the assembly, slide the seat and footplate into place (see following image for correctadjustment). This ensuresthat the seat and footplate cannot slip in normal use. Tripp Trapp Assembly InstructionsWhen assembling your Tripp Trapp, do not fully tighten the bolts until you have fitted andcorrectly adjusted the seat and footplate as shown further down the page. Then fully tighten the bolts downboth sides of the chair.You may have to hold the metal rods to prevent them from turning whileyou tighten the bolts for the rods.NB: It is normal that that side frames may not fully butt up against the metal rods. (See instructionsfurther down page)Once you have fitted the seat and footplate stand the chair on a flat surface and ensure that theseat and footplate are square so that the chair doesn't wobble. If you are using a Stokke Harness with your Tripp Trapp and Babyset this would bethe ideal time to attach the D-Ring harness attachments to the seat plate. Footplate AdjustmentTo complete the assembly, slide the seat and footplate into place (see following image for correctadjustment). ![]() Tripp Trapp Assembly InstructionsWhen assembling your Tripp Trapp, do not fully tighten the bolts until you have fitted andcorrectly adjusted the seat and footplate as shown further down the page. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |